The absolute and final SPECIFICATION FOR WASHERS
- if it is split, then it is broken and must be replaced.
- if it is wavy, then it must be flattened until correctly shaped.
- if it has any sharp edges or serration's then it is a safety hazard and should be fenced off until safety dept can safely dispose of it.
Any washer holes found to be smaller than the bolt should be rejected immediately.
Any holes found to be bigger than the washer should be fillet welded until the washer stops dropping through.
A washer is not required if there is no nut and bolt, do not check for washers during compaction tests, megger tests, etc.
A washer is required if there is a nut and bolt, but only if the bolt is too small for the hole and keeps dropping through it.
Any holes found without a bolt through it should have a washer attached immediately, in case it is later used for a bolt hole.
INSTRUCTIONS - read very carefully!!
All washers must be washer shaped,
No comments:
Post a Comment